Sections of a lawn can get jammed using rainwater due to dirt that doesn’t drain well or because there is a very low spot that fills fast with no escape route to the liquid. If your lawn develops muddy or mushy spots following a rain, or worse, each time you use a sprinkler, fix the issue by adding draining materials and fixing the low spots.

Permit the mushy yard area to dry out as much as you can, then scoop the grass away with a shovel. Place it to the side to be utilized afterwards. Dig out the grass around the low area, and in addition, dig a route in the wet area toward the edge of the street in which a drain is located or toward your plant beds.

Raise the low area with topsoil till it becomes with the surrounding lawn. Low places have a tendency to trap water, and this is going to keep the space form getting too mushy. Tamp the soil down to help it settle.

Dig a trench along the path you made to the edge of the street or natural areas. Maintain a slight downward slope away from the issue area of 1/4- to 1/2-inch for each four feet. Initiate the trench at a depth of 10 inches and operate from there. Make the trench 8 inches broad. Use a level to check the slope.

Fill the base of the trench with 2 inches of gravel to maintain the drainpipe off the soil. Mix some sand with the gravel to keep dirt from settling in between the stones.

Place a perforated 4-inch diameter drain from the trench bed. Utilize a mesh sleeve above the drainpipes to prevent dirt from clogging the holes. Place the pipes so that the holes are facing down. Surplus water will drain in the trench and seep into the holes since the water level rises. It will also flow from the holes further down the lawn in regards to a region that isn’t already wet. Whatever is left will get to the end of the pipe in the street or plant beds.

Fill around the pipe the sides of the pipe with gravel, and place 2 inches of gravel on top of the pipe. Mix with a small sand to fill in some of the larger gaps that the gravel produces. Both sand and gravel allow water to flow freely.

Add 2 inches of mud over top the gravel to seal it and prevent topsoil from mixing with the gravel. Place the grass that you set aside back in place above the low area in the lawn. Water the grass.

See related