Of all the types of sidings that you will come across, vinyl is the easiest to install for siding installation Denver, CO. However, you still need professional support. If you do not install the vinyl siding properly, water will seep in and you will soon have pest control expenses too.

If you choose to install vinyl siding on your own, here are some useful tips that will help you avoid simple but common mistakes:

Use A Vinyl Blade

To cut the vinyl sections, a lot of people make the mistake of using a saw blade. Instead, get a special vinyl blade. With this blade, you will get a smoother cut. You will not have to worry about chipping or other difficulties in cutting, and your project will be a success.

Leave End Spaces

After the installation, your vinyl siding should have some space at the end for slight movement. This space is for expansion, especially during the hot months. Without this space, your siding will buckle and you will have bigger problems. It’s safe to leave around ¼ inches at either end of the siding Denver, CO.

Locking Down The Siding

Try not to tightly lock down the siding against the wall. You must leave some space between the siding and the head of the nails. This will provide ample room for the siding to expand and contract depending on the prevailing weather conditions.

Consider A Wider Starting Strip

With vinyl siding, you will have a number of options for the starting strip. A lot of people tend to use the cheaper thin starter, which is a poor decision. Instead, set some money aside and get the 3 ½ inch strip.

At the point of installation, always make sure that you have at least an inch of the strip hanging over the foundation. It’s better to have the starter strip covering a good portion of the foundation, protecting it from snow, rain, etc.

Be Careful With The Installation

Imagine completing the installation and then the siding comes apart. To avoid this, make sure that when you are nailing the siding, you pull each piece up lightly. Keep doing this while nailing the Denver, CO vinyl siding. This process will create a strong bond between the 2 siding sections by locking them together.

Choose The Right Nails

For this job, make sure you use galvanized roofing nails. They usually withstand the pressure of different weather conditions and will keep your siding in place firmly. The nails should be no less than 2 inches long. In case you are installing over strong foam, use longer nails than the ones you use when installing against the sheathing.

Level It Out Carefully

Your siding is not installed properly until you level it. Leveling out will make the siding more functional. Start leveling from the beginning of the project, and then keep it going at intervals of 5 courses until you are through.

Flash Window Bottoms

You have to flash the corners of all the windows in your house before you start installing the vinyl siding Denver, CO. Cut a small section of the felt paper and insert it in the window corner you are working on. You can hold this in place with nails.

This is a simple procedure that prevents water from going behind the J-channels. If water penetrates these channels, the frame around your windows will rot.