Air ducts are effective and important, however they are able to be ugly in a basement or inside a home. When there is one ducts are installed in a basement, but a lot of houses are constructed without basements. In these circumstances, ducts must run or in some homes, through areas or garages. These ducts can be concealed by you, nevertheless, by within the the body with dry wall or alternative siding and framing around them. Ducts in what looks just like an attractive in the house dropped ceiling, if they’re flexible ducts or sheet-metal.

Measure the duct, while it’s flexduct or sheetmetal, using a tape measure to decide what size to create a frame. Add 1 1/2 inches for clearance; if a duct is 12″ for instance, the framing box should be 1 3 1/2 inches. Measure the amount of the duct you are going to enclose, on average from wall to another. The ceiling joists across the line for factors to fasten the framing.

Create depth, width and a framing box the size of the duct you are going to cover. Make the box of 2-by-2 inch lumber with two aspect “ladders” with a top and bottom plate and vertical “rails” in between, then link the ladders with boards across the bottom with a hammer and nails.

Cut four 2-by-2 inch boards to the size needed with saw. circular Measure off 2-by-2s in sections to make “ladders” for the box sides; make these to the depth of the duct less 1 1/2 inches, to to pay for the width of the THE TWO-by-2s plus the clearance. Cut ladder parts one foot to get a 12-inch duct, with the THE TWO, for example -by- the clearance being provided by 2 plate.

Fasten the ladder rails inside two extended 2-by-2s with facilities spaced 24 Two finish rails -by-2s first, to to make a long . that is rectangle Square the four corners of the rectangle using a velocity square, then install the rails that are the inner. Hammer; a fasten rails with 16d framing nails and set two nails in to the leading. each rail through

Mark 2-by-2s to to match across the bottom of the two ladder sections, spaced to the dimension of the duct plus a-T least an inch on each facet, 14-inches for a-12-inch duct, for instance. Cut one bottom rail for every side rail. Set along side it ladders contrary to the rails that were bottom and fasten them with framing nails, pushed to the rail through each aspect plate.

Lift the box that is completed in to spot; get assist maintain and to elevate it around the duct contrary to the ceiling. Nail the best ladder sides in to every ceiling joist with framing nails. Cover the box that is completed with dry wall, screwed or nailed to the box members, or with other ornamental siding or wood-paneling.

See related